Digirig Interface Cables for Select Kenwood HF Radios

• Coiled cable keeps things nice and tidy by preventing knots and kinks
• One serial RS-232 cable for CAT with DB9 connector and one Audio/PTT cable with Din-13 connector
• About 24″ relaxed, 72″ fully stretched
• Shielded and RF choked with ferrite beads on both ends to prevent RFI
• Premium quality materials and craftsmanship

This cable requires Digirig Mobile Revision 1.6 or later preconfigured for RS-232.

These cables can be used with following transceiver models:

• Kenwood TS-140S
• Kenwood TS-2000
• Kenwood TS-2000x
• Kenwood TS-570
• Kenwood TS-570d
• Kenwood TS-570DG
• Kenwood TS-570S
• Kenwood TS-570SG
• Kenwood TS-590S
• Kenwood TS-590SG
• Kenwood TS-690
• Kenwood TS-870
• Kenwood TS-940
• Kenwood TS-950
• Kenwood TS-990

Note: Digirig mobile is available in four different configurations. Configuration only matters if your transceiver is capable of serial CAT control or if you plan to use Digirig for programming the radio (firmware or settings), and is not strictly required for digital operations. You can still share a Digirig in incompatible configuration with a CAT capable transceiver if you don’t connect the serial cable.