Digirig Interface Cables for Lab599 TX-500

• Coiled cable keeps things nice and tidy by preventing knots and kinks
• One serial CAT with 3.3V power (GX12-4) cable and one Audio cable (GX12-7)
• About 24″ relaxed, 72″ fully stretched
• Shielded and RF choked with ferrite beads on both ends to prevent RFI
• Hardware PTT line in audio cable allows single cable operation, make sure RST line of serial port is normally inactive (HIGH)
• Digirig has capacitors on audio lines as required by TX-500
• Premium quality materials and craftsmanship

This cable requires Digirig Mobile Revision 1.6 or later preconfigured for TX-500.

Note: Digirig mobile is available in four different configurations. Configuration only matters if your transceiver is capable of serial CAT control or if you plan to use Digirig for programming the radio (firmware or settings), and is not strictly required for digital operations. You can still share a Digirig in incompatible configuration with a CAT capable transceiver if you don’t connect the serial cable.