Icom IC-7300MK2 HF/50MHz SDR Transceiver
NOTE: This radio is not FCC approved. This listing is not an offer to sell the IC-7300MK2. You can request stock status notifications by clicking "Request Stock Alert" above.
The IC-7300MK2 is a next-generation compact HF transceiver, building on the worldwide success of IC-7300 which sold over 100,000 units globally. There has been no official price announcement from Icom America, but we expect this radio to retail from $1499 to $1799 when it is released.
Key New Features
- Improved RMDR and Phase Noise Characteristics
- Lower Heat Generation and Lower Power Consumption
- HDMI™ Port for an External Display
- Built-in CW Decoder
- Simplified RS-BA1 Remote Control with Ethernet connector
- USB Type-C™ with Dual COM + Audio
- RX Antenna IN/OUT Connectors
Enhanced Performance
Improved RMDR and Phase Noise Characteristics
The IC-7300MK2’s RMDR is improved to about 105 dB* typical (at 2 kHz separation) and transmit Phase Noise characteristics are improved by about 12 dB (at 1 kHz frequency separation) compared to the previous model. The superior Phase Noise characteristics reduce noise components in both receive and transmit signals.
Lower Heat Generation and Lower Power Consumption
Through component selection and DC power optimization, the IC-7300MK2 reduces heat generation and enables stable operation during extended operating periods, such as contest operation. Compared to the previous model, the IC-7300MK2 reduces power consumption from 0.9 A to 0.7 A (typical) during RX standby.
New Features
HDMI ™ Port for an External Display
As a first for Icom’s HF/50 MHz radios, the IC-7300MK2 incorporates an HDMI™ port for external display connection. Operating information, such as frequency, scope, waterfall, and menus, can be shown on a large monitor, and audio can also be output through HDMI™ to the display’s speakers.
RX Antenna IN/OUT Connectors
The RX Antenna IN/OUT connectors enable you to take advantage of antenna characteristics for optimized reception, such as avoiding interference and QRN. External bandpass filters and preamps can also be connected to these connectors.
Simplified RS-BA1 Remote Control
Whether from a remote location within your home QTH, or from a remote location somewhere around the world, the RS-BA1 (Version 2) software enables you to operate your IC-7300MK2. With the addition of an Ethernet connector, a base station computer is not required. You are able to remotely turn the radio ON or OFF through the Internet.
Built-in CW Decoder
Another first for Icom’s HF/50 MHz radio, the IC-7300MK2 can decode Morse code signals without using a PC or other external equipment. The decode filter automatically follows the target signal, and keying speed is automatically adjusted.
USB Type-C ™ with Dual COM + Audio
The IC-7300MK2 provides a USB Type-C™ port with dual virtual COM ports and audio In/Output. You can use two applications simultaneously,such as FT8, logging and contest software, with just one USB cable
