8.5oz Black Laser Marking Spray for all xTool machines

Black Laser Marking Spray (8.5oz)

Key Specifications

• Material Type: Other
• Quantity: 1 PCS
• Volume: 8.5 oz
• What's Included: 1 x Black Laser Marking Spray

Compatible Machine

• All xTool machines

Processing Mode

• CO2-Laser Engraving
• Blue-light Laser-Laser Engraving
• Fiber Laser-Laser Engraving
• MOPA Laser-Laser Engraving

Product Details

Black laser marking spray is applied to the surface of the material and then combined with the xTool machine, which creates a unique black pattern with high contrast and durability. It can be applied to a wide variety of materials such as most metals (stainless steel, copper, aluminum), glass and ceramics. Please note that the spray is initially white in color, but will turn black after laser engraving. It can help the Blue-light Laser to achieve engraving on glass, but the glass will not show a black effect when engraving is used on it.

Compatible with CO2 (25-watt minimum), Diode (10-watt minimum), and Fiber (10-watt) lasers. Easy and quick to use, just simply spray and engrave to create black marks.

Important Usage Instructions:

• This spray contains powder and should be shaken well before use, but avoid shaking too vigorously, as this may cause a bulge at the bottom. Shake until you hear the glass bead moving, it’s ready for use. Shake the bottle for 2-5 minutes before use for best results.
• During use, the spray should not be shaken vertically, but rather from side to side.
• Additionally, the spray should not be exposed to direct sunlight.
• The best spraying distance is 6-8 inches.
• After spraying, dry at room temperature for 10-30 minutes, or use a heat gun to speed up drying. The spray should be **completely dry** before engraving with the xTool machines.
• Remove any remaining marking spray with water and a rag after engraving.
• Please note that if you don't use it all at once, be sure to clean the valve by turning the can upside down and pressing the nozzle until only gas comes out after use. The next time you use it, it will not be clogged to avoid the situation of not being able to spray. You can avoid possible leaks by shaking it a few times after each use and pressing the nozzle a couple of times to get any powder that may be attached to the gasket inside the valve out.