Creality Filament System (CFS) for K2 and Hi Series 3D Printers

Snap-Away Support Enabled
CFS is able to deliver model supports in a different material that can be easily snapped away or even water-soluble. The resulting 3D model will not show any support marks

Auto Filament Identification & Auto Filament Switch
Upon loading an RFID-tagged filament, CFS will read its type, color, etc., and sync them to your 3D printer For regular filaments, you can also edit the info manually. CFS can switch filaments fluently and precisely for a multicolortask. It can also relay a running-out spool with a similar one installed. Minimal interruption and waste. *Not compatible with flexible TPU, damp BVOH/PVA, or warped cardboard filament spools

Auto Run-Out/Tangle Detection & Auto Filament Mapping
Sensors are used to watch over each spool of filament. When a filament runs out or gets tangled, it will pause and notify you immediately. Upon loading an RFID-tagged filament, CFS will read its type, color, etc., and sync them to your 3D printeer For regular filaments, you can also edit the info manually.

Spring-Loaded Batten Bar & Cardboard Spool Compatibility?
No more filament jumping out of the slot during printing. Perfectly adapted to Creality Hyper Series cardboard spools.