Digirig Interface Cable for Select Icom Mobile Radios

• Data cable allows digital modes and packet radio protocols as FT8, FT4, SSTV, APRS, Echolink, Allstar etc
• Great for working satellites (e.g. APRS and SSTV)
• Data cable combines audio and PTT control, plugs into Digirig’s audio socket
• Coiled cable keeps things nice and tidy by preventing knots and kinks
• Coiled part is about 24″ relaxed, 72″ fully stretched, mic cable is ~6″, speaker cable is ~18″
• Shielded and RF choked with ferrite beads on both ends to prevent RFI
• Premium quality materials and craftsmanship
• Some radios this may work with: IC-208H, IC-2300H, IC-2710/20/30, IC-V8000, ID-800H, and ID-880H

The audio cable requires Digirig Mobile Revision 1.6 or later (any configuration).

According to unverified compatibility lists this should work with the below transceivers:

Alinco

Alinco DR-605, Alinco DR-605E

ICOM

ICOM HM-133V, ICOM IC-207H, ICOM IC-208H, ICOM IC-2100H, ICOM IC-2200H, ICOM IC-2300H, ICOM IC-2702H, ICOM IC-2710H, ICOM IC-2720H, ICOM IC-2725E, ICOM IC-2730, ICOM IC-2730A, ICOM IC-2800H, ICOM IC-2820H, ICOM IC-E208, ICOM IC-E2820, ICOM IC-E880, ICOM IC-F110, ICOM IC-F111, ICOM IC-F121, ICOM IC-V8000, ICOM ID-4100A, ICOM ID-4100E, ICOM ID-800H, ICOM ID-880H

Kenwood

Kenwood TM-271, Kenwood TM-271a, Kenwood TM-281, Kenwood TM-281a

Note: Digirig mobile is available in four different configurations. Configuration only matters if your transceiver is capable of serial CAT control or if you plan to use Digirig for programming the radio (firmware or settings), and is not strictly required for digital operations. You can still share a Digirig in incompatible configuration with a CAT capable transceiver if you don’t connect the serial cable.