Digirig Interface Cable for Yaesu MiniDin10

Digirig Mobile Rev 1.6+ Audio/PTT cable for FTM-6000R and other Yaesu transceivers using proprietary 10 pin MiniDin connector.

• cable works with Mobile Yaesu transceivers using proprietary 10 pin MiniDin connector
• data cable allows digital modes and packet radio protocols as FT8, FT4, SSTV, APRS, Winlink, Echolink, Allstar etc
• great for working satellites (e.g. APRS and SSTV)
• data cable combines audio and PTT control, plugs into Digirig’s audio socket
• coiled cable keeps things nice and tidy by preventing knots and kinks
• about 24″ relaxed, 72″ fully stretched
• shielded and RF choked with ferrite beads on both ends to prevent RFI
• premium quality materials and craftsmanship

The audio cable requires Digirig Mobile Revision 1.6 or later (any configuration).

Some of the transceiver models that can be interfaced using this cable:

• Yaesu FT-100DE,Yaesu FT-100DR,Yaesu FT-400DR,Yaesu FTM-300DE,Yaesu FTM-300DR,Yaesu FTM-400DE,Yaesu FTM-400XDE,Yaesu FTM-6000E,Yaesu FTM-6000R

Note: Digirig mobile is available in four different configurations. Configuration only matters if your transceiver is capable of serial CAT control or if you plan to use Digirig for programming the radio (firmware or settings), and is not strictly required for digital operations. You can still share a Digirig in incompatible configuration with a CAT capable transceiver if you don’t connect the serial cable.