Ready to learn about electronics using the Raspberry Pi? Version 2 of our Project Kit contains LEDs, sensors, WiFi module and other electronic components that you can attach to the Pi's GPIO port. It's a great starting point into a world of Pi powered projects.
Notice that bright, shiny row of header pins on your Raspberry Pi? These are GPIO (general purpose input / output) pins that can be read to and controlled through programs written on the Pi. This kit includes a selection of hand-picked components and documentation to allow you to use the GPIO pins to power your projects.
In case you don't know, the Raspberry Pi 2 Pi Model B included in this kit is based around a Broadcom BCM2836 system on a chip. It includes an Quad Core, 900MHz ARM7 processor, VideoCore IV GPU, and 1 Gigabyte of RAM. This board is intended to run Linux kernel based operating systems from a MicroSD card that acts as a solid-state hard drive.
Kit Contents:
- Raspberry Pi 2 Model B Single Board Computer
- MicroSD Card w/Adapter Containing 6 Different Operating Systems
- 5VDC 2A Power Supply with MicroUSB Connector
- Clear case
- 6Ft HDMI Cable
- USB WiFi Module
- GPIO Breakout Board
- Full-size breadboard
- Male Jumper Wire Kit
- 5 x 10K Ohm 1/4 Watt Resistors
- 10 x 330 Ohm 1/4 Watt Resistors
- 16V 1UF Electrolitic Capacitor
- 3 x Tactile Switch
- CDS Photoresistor
- 2 x 5mm Yellow LED
- 2 x 5mm Red LED
- 2 x 5mm Green LED
- 36 Page User Guide
