Q: What frequency range and resolution does the VNA 3G support?
The JNCRadio VNA 3G covers a frequency range of 50 kHz to 3 GHz.
It supports fine frequency steps of less than 100 Hz, making it suitable for detailed narrow-band measurements.
The device scans at up to 400 points per second and supports up to 501 points per sweep for high-resolution analysis.
Q: Is the VNA 3G suitable for measuring narrow-band crystal (Xtal) filters?
Yes.
The VNA 3G supports very small frequency steps and is well suited for measuring narrow-band filters with center frequencies below 140 MHz.
It can accurately analyze filter bandwidth, insertion loss, and frequency response characteristics.
Q: What are the differences between the current VNA 3G version and the earlier version (f v2)?
The current version includes several important improvements:
– Scanning speed increased by 4× to 400 points per second
– Maximum sweep points increased to 501 points
– Up to 13 calibration state storage slots
– SNP files automatically named with RTC time
– A more powerful processor for smoother operation and future firmware upgrades
These enhancements improve measurement efficiency and workflow.
Q: Does the VNA 3G support TDR (Time Domain Reflectometry)?
Yes.
The VNA 3G includes TDR mode for time-domain analysis, allowing users to evaluate impedance changes along transmission lines and cables.
Q: How can I export measurement data?
Measurement results can be saved in two formats:
– Screenshots – Saved as image files (via desktop software)
– Trace data – Saved as standard .S1P files
Trace data can be transferred to a PC when the device is connected as a USB storage device.
Q: Can the VNA 3G be controlled from a PC?
The VNA 3G supports PC connectivity for data transfer and capture, and is compatible with many analysis tools. While remote control is not the primary workflow, trace export and visualization via PC software are supported.
Q: What are the battery and charging specifications?
The VNA 3G includes a built-in rechargeable battery.
It charges via standard 5V USB power supply (5V/1A or above recommended).
Battery level indication is supported in newer firmware versions.
Q: Is there a battery level indication?
Yes.
Battery display format may vary depending on firmware version. We recommend updating to the latest firmware for the best user experience.
In newer firmware versions (v1.1.0 and later), the battery level is displayed on screen.
In earlier firmware versions (v1.0.2 and previous), battery status is shown as voltage. It is recommended to recharge the device when the voltage drops below 3.4V. The device will automatically power off if the voltage drops below 3.2V to protect the battery.
Q: Does the VNA 3G come pre-calibrated from the factory?
The device is factory tested before shipment.
However, like most compact VNAs in this category, users should perform calibration before each measurement session to ensure optimal accuracy.
Q: Where can I download firmware updates and software?
The latest firmware, desktop software, and user manual can be downloaded from the official Chelegance website under the DOCUMENTATION section of the product page.
We recommend keeping your device updated to the latest firmware version for optimal performance.